Source Setting
Last updated
Was this helpful?
Last updated
Was this helpful?
AXView 3.0 provides industrial protocol Modbus RTU and Modbus TCP to collect data and control devices.
1) When you click “+” button at bottom-right corner, a popup window will appear.
2) Fill up the required parameters Device Type.
Modbus TCP: Enter IP Address, and Slave ID. Click the “Search” button along the identifier category.
Modbus RTU: Enter the Slave ID. Then click on “Add Device” button to complete the registration.
3) Click on “Accept” button to connect the new Modbus device with the system.
4) Once connected “Accept” button will change to “Reject” button.
Once the new Modbus is added, we can know configure the device into its required parameters. Depending on the use case, respective parameters would be filled in. Steps are as below:
1) Click on the “Configure” button.
2) New popup window would appear. Fill in the respective parameters for each use case of the Modbus. Click “Add Register” button to add the new parameters into the system.
3) Once successfully added, the respective parameters will appear in the list.
